RadSamp - PC Based Sample Player

Specification and Features

Two banks of up to 10 channels with fully independent control of tempo, volume, loop on/off etc.

Instantly Play any channel(s) from keyboard, mouse or external control.

Pause / Resume any channel

Pause / Resume last played channel using space bar.

Pitch bend last played channel by +/- 1%

Select / Monitor any channels play position, length, sample rate and tempo whilst playing.

Select / Adjust any channels overall tempo and volume whilst playing.

Save bank files while playing - no limit to number of bank files (except disk capacity!)

Browse for sample files while playing using standard Windows dialogue box.

RadSamp loads complete samples into system memory at present, for best performance and instant start playback.  A typical Pentium 166MMX with 32MB Ram should be able to load and play up to 20MB of samples at once, with no other applications loaded.  These figures are a guideline ONLY - as systems vary widely in performance and configuration.

RadSamp will play 10 or more samples at once, typically all 20 - although please note that a PC keyboard is the limiting factor in starting more than a few samples together. Latency is normally undetectable, where the system has enough free memory to load all samples.

Samples MUST be .wav format, almost all .wav variants are supported. 
Note. Other formats can be converted to .wav format using audio editing software.

Each channel can be adjusted in volume from 0dB to -30dB and tempo from -10% to +10% in 0.1% steps.

One bank can be loaded while the other is playing, subject to system performance.

For further information, email: rdowns@radix.co.uk